Mar 01

BotM – Louver Section and Elevation

This month’s BotM is a bonus 2 for 1 download.  The louver section can be adjusted to any height via a stretch action.  The louver vanes are then added via an array action to fit within your specified height.  The louver elevation uses stretch actions to set the width and height and includes a solid white hatch behind the linework to block out whatever exterior finish is behind.  Use the draworder command to bring the louver to the front and there will be no need to trim finishes behind.  Head on over to the downloads page to grab these louver blocks and others! Also, if you like this block, feel free to check out my entire collection of dynamic blocks on Autodesk’s Exchange Apps Service.

Take a look at the quick clip below to see this months block in action…